Waring WC1000 Especificaciones descargar pdf (Pagina 2)

TABLE OF CONTENTS

INTRODUCTION/WARRANTY ....................................................................................................................................... 1

RCS-1000 SPECIFICATIONS........................................................................................................................................ 3

INSTALLATION AND SETUP .......................................................................................................................................... 3

OPERATION ............................................................................................................................................................. 4

REAMER BLADE SELECTION CHART ............................................................................................................................... 4

RCS-1000 SCHEMATIC/WIRING DIAGRAM ............................................................................................................... 5-6

PART LIST – RCS-1000 ............................................................................................................................................. 7

WC-1000 WIRE CUTTER SPECIFICATIONS .................................................................................................................... 8

WC-1000 DESCRIPTION/INSTALLATION AND PARTS LIST ................................................................................................. 8

INTRODUCTION

Thank you for purchasing an American Weldquip product. The American Weldquip product you have

purchased has been carefully manufactured, assembled and fully tested. This manual contains information on

the installation, operation, maintenance and replacement part breakdown. Please read, understand and follow

all safety instructions, warnings and procedures. Keep this manual handy for referencing installation,

operation, maintenance and part ordering information. While every precaution has been taken as to the

accuracy in this manual, American Weldquip, Inc. assumes no responsibility for errors or omissions. American

Weldquip, Inc. assumes no liability for damages resulting from the use of the information contained in this

manual. American Weldquip, Inc. shall have no liability to the buyer for consequential damages or expenses by

any defect whatsoever.

WARRANTY

AMERICAN WELDQUIP MIG guns and parts are warranted to be free of defects in material and/or workmanship for the

period of time listed below. For any product found to be defective under normal use, AMERICAN WELDQUIP, INC. at our

option, will repair, replace or issue a credit for the value of the defective product. All warranty claims must be submitted by

the original purchaser. Use of non-genuine AMERICAN WELDQUIP parts and/or consumables may damage and/or severely

limit the performance of the equipment which may limit or void any warranties. AMERICAN WELDQUIP, INC. will not

assume responsibility for incidental damages or expenses related to any defect. This warranty does not cover damage

caused by misuse or abuse, accident, alteration of product, improper installation, misapplication, lack of reasonable care

and maintenance, unauthorized repairs or modifications, loss of use while at a repair facility or other conditions that are

beyond the control of American Weldquip, Inc.

A Return Authorization Number (RA#) must be attained from the factory for any product being returned for Warranty

Repair or Replacement. All returned product must be shipped freight prepaid by the sender. No- charge replacements,

repaired products, or credit will be issued, once the returned product has been evaluated and warranty condition has been

verified. If an immediate replacement is required before proper warranty evaluation, a purchase order number is required

and the goods will be invoiced. A credit will be issued once it is determined that a warranty condition exists.

STANDARD WARRANTY

All Semi-Automatic, Automatic, Robotic MIG TORCHES and Components = 120 Days

MIG Torch Trigger Switches (Contacts only) -Excludes Smoke Extraction = LIFETIME

Robotic Nozzle Cleaning Stations, Wire Cutter = 90 Days

Robotic Peripherals, ArcSafe, Gun Mounts = 90 Days

TIG POINT Tungsten Electrode Grinders = 90 Days

LIMITED EXTENDED WARRANTY PROTECTION

This limited extended warranty protection expands coverage to loyal customers who use all GENUINE American Weldquip

1 2 3 4 5 6 7 ... 11 12

Comentarios a estos manuales

Sin comentarios

Waring WC1000 Especificaciones Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Waring WC1000